Translator

Français/French Deutsch/German Italiano/Italian Português/Portuguese Español/Spanish 日本語/Japanese 한국어/Korean 中文(简体)/Chinese
Simplified
Select Language:

Free Tutorial ~ Twisted Wire Beaded Cross Pendant

23rd July 2013 (Tuesday) @ 8.52pm

Hello!  I'm sharing here, a tutorial on how to make a Twisted Wire Beaded Cross Pendant.  
It's a simple pendant using a length of wire, some seed beads and basic twisting technique.  You need to have basic knowledge of wire twisting and wire wrapping techniques, and the fun part is that it will only take you about 10 - 15 minutes to complete. 

TWISTED WIRE BEADED CROSS PENDANT




 A pair of Twisted Wire Beaded Cross Earrings made in a smaller version.

Ok, let's get started ...............


1.  MATERIALS & TOOLS NEEDED FOR THIS PROJECT:
(Pendant size ~  Approximately 3cm x 5.5cm)

22g wire
11/0 size seed beads of your choice
Wire cutter
Round nose plier
Flat nose/bend nose plier
Nylon jaw plier (optional)
Ruler



2.  Cut a length of 22g wire, measuring 24cm long.
Straighten/smoothen it with nylon jaw plier.


3.  Bend/fold the wire in half and leave a little space as shown.


4.  Insert the seed beads into one of the wires until it is about 2.5cm long.  I've inserted 13 seed beads here.  If you want it to be longer, then add a few more.  


5.  Twist both wires together & secure the twisted length of beads (I have 15 seed beads on this twisted wire) by twisting the wire once at the top.  You can use your fingers or the nylon jaw plier to twist but do not put too much pressure as you may break the seed beads.  


6.  Spread out both wires ~  one to the left & the other to the right, as shown. 
 Insert 7 beads.   


7.  Next, bend/fold down the wire just after the seed beads as shown.


8.  Again, twist both wires simultaneously with your fingers or nylon jaw plier.
 Be careful not to break the seed beads.


9.  Repeat the same for the other side.
  It doesn't matter which side you do first.  Bring the two straight wires
 to meet in the centre and bend them upwards.  


10.  Again, insert 7 seed beads into one of the wires and twist both together.


 11.  Secure the beads with 2 wraps to the top and trim excess wire.


12.  Make a wrap loop with the other wire and you're done.  


Voila! 
 You've completed a simple pendant which can be worn with 
your favourite chain or cord.  

NB:  The photos were taken with my Nokia N97 and these are the best shots that I've selected.  






  • Digg
  • Del.icio.us
  • StumbleUpon
  • Reddit
  • RSS
Read Comments

0 comments:

Post a Comment